MEASUREMENTS

UNIVERSAL JOINTS

UJOINTS 

CAP DIA

CAP WIDTH

SNAP RING STYLE            OUTSIDE/INSIDE​

SLIP YOKE

A)AND B) UJOINT

D) HUB

F) SPLINE COUNT

C) CENTER TO END MEASUREMENT

FLANGE

UJOINT

B) MALE OR FEMALE PLIOT AND DIAMETER

A) BOLT SPACING

CENTER TO CENTER 

C) PUSH IN THE SLIP YOKE TILL IT BOTTOMS OUT IN THE TRANS MISSION THEN PULL IT OUT AN INCH THEN MEASURE CENTER OF THE JOINT IN THE FRONT TO WHERE IT BOLTS UP ON THE DIFFERNTIAL

​

CENTER TO FLANGE FACE/ FLANGE FACE TO FLNAGE FACE

WHERE IT BOLTS UP IN THE FRONT TO WHERE IT BOLTS UP IN THE REAR

CENTER TO CENTER CARRIER BEARING TO CENTER

MAKE SURE YOU PULL THE SLIP YOKE OUT 1" 

CENTER TO CENTER CARRIER BEARING TO CENTER